The Reed Switch line of fuel senders fit tanks 4" to 60". They are designed for top mounting in aluminum, plastic, steel or stainless steel fuel tanks in all types of industrial equipment. These senders are recommended for both on-road and off-road applications. They include special features and protection from corrosion (internal and external to the fuel tank) which makes them the quality standard for all industries.
Standard mounting configuration, SAE 5 hole bolt pattern. The head and support are made of stainless steel and is suitable for harsh off-road conditions. The sender is suitable for gasoline, ethanol, diesel, bio-diesel, urea and water.
Industry standard output: 240-30 ohms. The close tolerances held on this series of Reed Switch fuel level sender will provide the proper signal for any of the popular 2" panel mounted quality receivers or ECM's.
Note: SAE Gasket included.
Features
- Comes with SAE gasket and flying leads
- 240-30 ohm output
- Head: Stainless steel
- Support: Stainless steel
- Float: Nitrile rubber
- Material Compliance: RoHS Compliant
Specifications
- Accuracy: System accuracy depends upon proper sender sizing. Resistance values are 30 ohms ±2% at full and 240 ohms ±2% at empty. System accuracy may depend upon tank shape. System accuracy may be less if tank is not level.
- Temperature: -40°F to 176°F, -40°C to 85°C
- Power: 0.5 watts maximum
- Leak Test: Passes 16 PSIG [1,1 BAR] test
- Gasoline Rocker Test: 3,000,000 cycles
- Thermal Shock/Hot Dunk Test: 10 cycles in air, +85°C to immersion in room temperature saline
- Dry Bench Cycling: 25,000,000 cycles
- Vibration Test: 6 hours each plane, 9.9 Grms, 24-2,000 Hz
- Salt Spray Test: 96 hours external as mounted
- Drop Test: 1.2m onto concrete from each orientation
- Power Wash Test: 50 cycles, 3,000 PSI, 2.7 gal./minute
- Lead Pull Test: 20 lbs. harness, 10 lbs. each wire
- Wiring Harness: 18 awg. wires, black & white PVC instulation, black overmolding PVC jacket
