Side pan grate only is used as part of the design/integrity for walking on or setting up drive over points. Personnel do not have to walk in spilled product in Pans due to grating in every pan, reducing liability. Ultra-Track pans capture hazardous spills from railroad tanker cars. Ultra-Track Pans have been designed to provide railroad spill containment at industrial rail sidings and locomotive maintenance facilities. The modular design can be used for spill control for everything from small drips during maintenance to catastrophic spills from tanker cars. Available in virtually any length, Ultra-Track Pans may be used to collect small spills and leaks OR to capture and channel off significant spills caused by defective equipment or a major overflow. Prevent costly cleanup and regulatory fines from railcar spills and chemical spills. Modular Track Pan design can be customized to meet your specific railroad spill containment needs. Long work life - Estimated to perform 20-30 years.
Note: Approval needed see the Rail Height Approval Sheet attached to confirm all is needed based on area covered & system looking to be put in place. Lead-times can vary. Call a JME Sales specialist 800-333-3331 to get the detailsFeatures
- Modular design - Center and Side Pans are 53.5" long; railroad spill containment areas can be easily assembled to any length desired
- All-polyethylene construction - Rugged Track Pans withstand harsh chemicals and are designed to function in temperatures ranging from -40°F to +140°F
- UV inhibitor in polyethylene resin resists degrading effects of sunlight, adding years to outdoor service life.
- Trucks and other vehicles can drive over Track Pans with grates in place (NOTE: To drive over Track Pans, firm footing must be beneath the Pans; also must "ramp up" to Side Pans with asphalt or concrete)
- Low Maintenance - unlike carbon steel track pans, Ultra-Track Pans will not rust or corrode. Polyethylene resin is treated with a UV inhibitor, resists degrading effects of the sun.
- Low Cost Installation-Lightweight Track Pans can be easily installed without heavy lifting equipment, i.e., forklifts, cranes, backhoes, etc. Minimal tools and labor required.
- Slip Resistant Surfaces - Pans, grates and covers have been designed with safety in mind. All top surfaces resist slips when wet or oily.
- Lightweight covers mechanically lock into the polyethylene decking and will not blow off in windy conditions.
- Protected by the industry's strongest warranty - Five (5) years against any material or workmanship defects.
Specifications
- A Side track pan w/ grate only
- Meets SPCC and EPA regulations
- Made in the USA
Downloads
Brochure (PDF Download)
Specifications (PDF Download)
Instructions (PDF Download)
Chemical Compatibility (PDF Download)
Adhesive SDS (PDF Download)
SDS (PDF Download)
Rail Height Spproval Sheet (PDF Download)
